Geheimnisvolle Welten - Tajemnicze światy - Mysterious worlds - Dr. Jan Pająk

Normale Version: S1.3. Twin-chamber capsules formed from two Oscillatory Chambers are frequently...
Sie sehen gerade eine vereinfachte Darstellung unserer Inhalte. Normale Ansicht mit richtiger Formatierung.
@ Dr. Ing. Jan Pająk

S1.3. Twin-chamber capsules formed from two Oscillatory Chambers are frequently observed in UFOs and even photographed
 

The central magnetic circuits of ascending discoidal UFOs produce a unique magnetic-lens effect which facilitate visual observation of twin-chamber capsules from the main propulsors of these vehicles. This effect allowed a number of outside witnesses to see and to precisely describe twin-chamber capsules in UFOs, and to even photograph this capsule on numerous occasions (see Figure S5). The mechanism involved in producing this magnetic-lens effect is the subject of explanations in subsection F9.4.1 /?/ and it is also illustrated in Figure F32 /?/. But because of its evidential value in deductions from this chapter, for the consistency of presentation this effect is also briefly summarized below.
In ascending UFOs the power of the magnetic field involved in a vehicles' central magnetic circuit exceeds many times the power involved in the main and side circuits. For this reason force lines of the central magnetic circuit hermetically surround not only the entire body of such an ascending UFO, but also its main and side magnetic circuits, which became wrapped in a kind of magnetic donut. Principles involved in the formation of this donut are illustrated in Figure F32 /?/. As this was stressed in subsection F9.4 /?/, the extremely concentrated magnetic field of a UFO interferes with light. This interference in general depends on allowing the light to pass easily along the field force lines, but bending paths of the light which tries to pass across these lines. The mentioned magnetic donut formed around the ascending UFO means that to reach the vehicle's shell the light would need to pass across the donut's field force lines. But in order to reach the main propulsor, the light would need to follow these lines. For this reason, the outside observer who witnesses an ascending UFO can easily see a twin-chamber capsule from the main propulsor, but he/she is unable to see any other part of the vehicle's shell.
Stanislaw Maslowski of Wroclaw, Poland, was the first UFO observer who drew my attention to this magnetic-lens effect. He witnessed a UFO which took-off from ground level. While watching it rise, to his astonishment he noticed that the entire body of the vehicle gradually diminished and only a small diamond-shaped device (i.e. a twin-chamber capsule from the main propulsor) in its centre became visible. Below is provided a description of his sighting.
On the 29th August 1979 at about 7 PM, 9 year old Stanislaw Maslowski of Wroclaw, Poland, encountered a K3 type UFO in the Popowice Park of Wroclaw. The object was hovering at a height of about a half a metre, and two (out of three) members of its crew had left the deck. The witness came to the vehicle at a distance of about 6 metres, approaching the nearest UFOnaut at a distance of about 2 metres. The encounter took about 10 minutes and provided numerous technical details of the object and its crew. Afterwards, Stanislaw observed this UFO taking-off. When the vehicle only slightly increased its height, the body of its shell began fade away, although the UFO was still too close for Stanislaw to lose his clear visibility because of the distance. Simultaneously, exactly in the centre of the former body of this ascending vehicle appeared a much smaller device emanating a strong, dark-yellow light. Stanislaw described the shape of this device as resembling a "diamond" he saw on playing cards (i.e. a diamond is a shape which is obtained when one observes a square from an angle).
After Stanislaw Maslowski revealed the existence of the above effect, I began collecting other evidence. The analysis of the evidence accumulated so-far leads to the conclusion that the majority of witnesses who see and describe a square, rectangular, or diamond-shaped UFO which emits from the inside a strong, gold or yellow glow, in fact do not see the whole vehicle, but only the twin-chamber capsules from their main propulsors. The additional confirmation that these rectangular objects represent the arrangements of Oscillatory Chambers, not the entire vehicles (e.g. four-propulsor UFOs similar to those described in chapter D) is the unique glow of gold electric sparks always emitted from inside.
A good example of a typical sighting of a twin-chamber capsule from the main propulsor of an ascending UFO is the observation by Mr Wayne Hill of Invercargill, New Zealand. A drawing of the device that Mr Hill observed is presented in Figure S4. This is how he describes his sighting:
"It was about 11:30 PM, on 20th December 1978, shortly after sunset. I was having a walk alone along a road about 7 kilometres south of Nelson, New Zealand. The road in that place runs exactly in the south to north direction. I was walking northward. Rapidly, an uneasy feeling of being followed made me look up. Above my head, at a height of about 30 metres, a lit diamond-shaped outlet having the edge of about 10 metres, was silently passing through the sky. It was flying from south to north. Then it stopped moving and hovered above me. I noticed the edges of an outer cube, lit up by a kind of glow. In the centre of this lit cube, a face wall of another black one was visible. Between the edges of both cubes I noticed a strong yellow glow, which seemed to be more concentrated in the corners of the diamond. I had the impression that this glow came from a filament of a square bulb. The remaining, non-glowing space between both cubes was greyish in colour. Behind the edges of the outer cube I did not notice any remaining parts of a vehicle. My observation lasted only about 20 seconds. After this time the vehicle begin to ascend sharply and then disappeared from my view into cloud."
Sightings of twin-chamber capsules from the main propulsor of ascending UFOs constitute a large portion of all UFO observations. For example, such a sighting was the blueprint for shape D/7 drawn in Figure P8 of this monograph. It is also described in page 93 of the February 1982 issue (Vol. 4 No. 5) of OMNI magazine. Furthermore, the description of a UFO type K3 sighting, presented in the book [2S1.3] by Raymond E. Fowler: "Casebook of a UFO investigator, a personal memoir". Prentice-Hall, Inc., Englewood Cliffs, New Jersey, 1981, ISBN 0-13-117432-0, page 133, and discussed in subsection J2.9 /?/ of monograph [1], also reveals such a twin-chamber capsule.
The most objective documentation of twin-chamber capsules from ascending UFOs is provided in their photographs. A number of photographs of these capsules have already been taken, although their authors do not realize what their pictures reveal. Two examples of such photographs are shown in Figure S5. The first of these (left) taken during the day in Hawaii by a teacher, represents one of the best colour photographs of a UFO twin-chamber capsule working in a mode of "inner flux prevalence". It was published in the book [3S1.3] "Into the Unknown", Reader's Digest, Sydney, Australia, 1982, ISBN 0-909486-92-1, page 315. In the better quality copies of this photograph the cone of the magnetic field under the inner chamber is clearly visible. This cone hides the outlines of two further back edges of the capsule. The field looped into the circulating flux acts like a "black hole" creating the black space visible at this photograph. Because of the action of a magnetic lens effect described at the beginning of this subsection, apart from the twin-chamber capsule from the main propulsor of this vehicle, the rest of the vehicle of course remains invisible to the camera. Note that the other part (right) of Figure S5 shows also a night photograph of the UFO twin-chamber capsule operating in the mode of "outer flux prevalence". It was taken on 23 January 1976 above Clovis, New Mexico, USA, by a journalist. It is published in the book [5S1.1], page 49. On this photograph the resultant flux is produced by the outer chamber. This flux ionizes the air, therefore in the photograph it is visible as the verge of a glowing diamond (the second half of the diamond is emitting its light along the field force lines spread in a different direction, therefore it is not captured on this photograph). The inner chamber is producing the circulating flux which appears in the form of a black diamond which blends equally with black night environment.
In order to be able to recognize the meaning of both these photographs, it is necessary to know about the action of the UFO's magnetic lens (explained at the beginning of this subsection) and also to know the characteristics of the twin-chamber capsules in their "inner flux prevalence" and "outer flux prevalence" modes of operation (these characteristics are illustrated in Figure C6 and discussed in subsection C7.1 /?/). Of course, for the researcher who is well acquainted with the above scientific foundations, the photographs of UFO twin-chamber capsules are the source of numerous data allowing to verify the correctness of the Theory of the Magnocraft. For example, both photographs shown in Figure S5 document that the equation (C9): ao=ai√3 is correct and the proportions of the dimensions that it expresses are really met in twin-chamber capsules from UFOs.

=> S1.4.